Prosil 41LM

1. Cut nozzle at a sharp angle slightly wider than the desired bead.
2. Extrude sealant with a gun and tool with a round spatula within 10 minutes to spread the sealant against the joint surfaces.

Limitations:
Prosil 41LM is not recommended for use:

• On submerged joints where porous substrates permit water to the bond interface.
• For certain rubber products where bleeding of plasticiser may occur, check with us if unsure.
• In aquarium construction and structural glazing. (Contact your Selleys representative for recommendations).

• All surfaces must be clean, dry, sound, and free from dust, oil, rust, or any other contamination.
• Metals should be cleaned with a non-oily solvent-soaked clean cloth.
• Solvent should be wiped from the surface with a clean dry cloth.
• Use an alcohol such as methylated spirits on glass.
• When used on remedial work all existing sealants must be removed.